Time left =
1 The size of a Shaper in specified by (SSC-JE: 2012)
2
Which part of the cutting tool is prone to crater wear? [SSC-JE: 2011]
3
For which machines, are very large speed range required?[SSC JE 2011]
4
In a shaper, metal is removed during [SSC JE 2011]
5
Orthogonal cutting system is also called [SSC-JE: 2011]
6
In a taper turning operation, maximum and minimum diameters of the job are D and d respectively. What is the-tapper angie, if the job length is L? [SSC-JE: 2011]
7
Select the correct sequence of the following parameters in descending order of influence on tool life
1. Feed rate, 2. Depth of cut, 3.Cutting speed [SSC JE : 2011]
8
The following type of chip is produced when machining ductile materials [SSC-JE : 2010]
9
Continuous chips are formed when machining [SSC-JE : 2010]
10
Milling machine is classified an horizontal or vertical type, depending on the position of - [SSC-JE : 2009]
11
For drilling operation the cylindrical job should always be clamped on [SSC-JE : 2009]
12
In which of the following operations on lathe,will the spindle speed be minimum [SSC-JE : 2009]