Electronics Engineer paper set 1 for practice

Free
Electronics Engineer Paper set 2
  Time left =

1

Each of the next items consist of two statements, one labeled as the Statement (I) and the other as Statement (II). You are to examine these two statements carefully and select the answers to these items using the codes given below: 


2

 Statement (I): A monostable multivibrator, when switched on remains in a quasi stable state.

Statement (II): Quasi stable state duration is decided by charging time of capacitor.
 


3

Statement (I): Emitter-Coupled Logic (ECL) family is designed for high speed. Statement (II): In this logic family, transistor does not operate fully in saturation or cut-off zones


4

 Statement (I): Switching speed of ECL logic family is very high.

Statement (II): The transistor used in the family remains unsaturated. 


5

 Statement (I): A flip-flop is a bistable multivibrator. Statement (II): A flip-flop remains in one stable state indefinitely until it is directed by an input signal to switch over to the other stable state


6

 Statement (I): Associative memory is fast memory. Statement (II): Associative memory searches by content and not by accessing of address


7

 Statement (I): PIN photodiode are preferred to PN photodiodes.

Statement (II): PIN photodiode is a constant voltage generator at a given light level


8

 Statement (I): A derivative controller produces a control action for constant error only.

Statement (II): The PD controller increases the damping ratio and reduces the peak overshoot


9

 Statement (I): Feedback compensation is preferred to series compensation.

Statement (II): No amplification is required as the energy flows from higher level to lower level


10

 Statement (I): A PI controller increases the order of a system by units but reduces the steady state error.

Statement (II): A PI controller introduces a pole at either the origin or at a desired point on negative real axis


11

 Statement (I): Many of the linear control system transfer functions do not have poles or zeroes in the right half of splane.

Statement (II): These are called minimum- phase transfer functions


12

Statement (I): Baud Rate and symbols per second are often used interchangeably.

Statement (II): Baud Rate refers to the rate of change of a signal on the transmission medium after encoding and modulation have occurred


13

Statement (I): Most TDM systems use PCM to transmit analog signals.

Statement (II): PCM uses A/D conversion technique to translate analog signals into binary form for serial transmission.